0

Day 6 of thing of the day

Posted by JFunk on 15/08/2015 in Gallery, Special projects, Uncategorized |

After learning a lot from the first pair of resto modded vintage headphones I have kicked it up a notch and done a better job on this pair. I have gone for much more expensive high end drivers and made custom laser cut wooden baffles and a pad adapter to fit the more comfortable HD25 pads
The drivers are 40mm with wool fibers in the cone and neo magnets so pretty fancy. I also made custom wire mesh grills to protec the cones and give it a bit more of a steampunk look 🙂

laser cutting

laser cutting wooden headphone baffles


Wool headphone drivers

High end headphone drivers with wool fiber drivers

Then I re-cabled the headphones with a nice vintage looking headphone cable and tested to make sure the drivers fit with the adapter

Modifuying Vintage headphones

Classic vintahe headphones with modern drivers and pads

Then they are all held together with hot glue and attach a wide body rean jack to finish the look

Steam punk headphones

Some steam punk headphones made by modifuying some vintage ones

The drivers are 32ohm so work great with portable stereos and phones. I will test them over the next few days and if all goes well it may be time to start selling them

facebooktwittergoogle_plusredditpinterest
facebooktwitterrssyoutubeinstagram

Tags: , , , ,

Leave a Reply

Copyright © 2009-2018 CustomCans.co.uk Custom Headphone Blog All rights reserved.
This site is using the Desk Mess Mirrored theme, v2.4, from BuyNowShop.com.